Thingiverse
Guided Filament Winder Puller Spacer
by JRD
1
Downloads
1
Likes
0
Makes
*This part is no longer necessary. You can use it if you already have a Puller v3, but the designer made a Puller v4 that has deeper nut recesses.*
The nut capture on the guided filament winder puller base is too shallow and prevented square mounting of my motor, so I made a spacer using my laser cutter.
The same geometry could be used to 3D print the part, extrude it to 1.5mm thick and print.
It is for this project:
http://www.thingiverse.com/thing:81662
The nut capture on the guided filament winder puller base is too shallow and prevented square mounting of my motor, so I made a spacer using my laser cutter.
The same geometry could be used to 3D print the part, extrude it to 1.5mm thick and print.
It is for this project:
http://www.thingiverse.com/thing:81662
Sign in to leave a comment
Sign in