Solidoodle 3 Heated Chamber Parts

I added 3 plexiglas sides to keep the heat in my Solidoodle 3 to assist with ABS printing. Very simple - 2 hooks, a knob, and a neodymium magnet superglued to the top. I ended up using the knob only on the front piece.

Cut three 13" x 13" square sheets of plastic - I recommend 1/4" thick if you're going out to get it, but it can be 1/8" or 3/16" or 3/8" if you have the scrap.

Mount the two clips on the bottom at the corners (shown in photo), and glue a magnet to each near the top. A 1/8