Huxley Techzone LM6UU x carriage (narrow)

Another lm6uu replacement carriage for the badly designed techzone x axis.
This one is narrow to keep 140+ mm of travel
It use only two LM6UU so make sure the zip tie are secured !

To use it you need to replace the imperial rods by 6mm rods and buy 2 LM6UU of course.
(it's up to you to replace the imperial by the 6mm, you may need to print new huxely part with 6mm hole instead of 6.35mm)

Don't forget to put a fan on it otherwise it will melt from the nozzle's heat(especially with PLA)