SLR Camera Lens Cap Single Print Experiment

This is the SLR Camera Lens Cap by simonx tweaked to print fully assembled.

The spring part was resized in one dimension only and 0.5mm of the springy part was sliced off so that it was at least 0.5mm away from the cap portion.

The overhang of the cap part that traps the springy part was cut away so that it had at least the same 0.5mm of empty space. The two parts have no supports between them when sliced by Cura.

This was printed as a test on the lulzbot mini in ABS with a 0.25mm laye