Back
GoPro Tilt Mount for Armattan F1-5/6 – 3D printable model from Thingiverse Thingiverse

GoPro Tilt Mount for Armattan F1-5/6

by FlatHat
13 Downloads
6 Likes
0 Makes
Download Model
This GoPro tilt mount is set at 27.5 degrees. It attaches directly to the existing mounting holes on the extra camera plate for the Armattan F1 5 and 6. Admittedly it's not the lightest accessory out there, but then neither is your GoPro, so if you're racing, you should probably take them both off.

*the velcro slot is a tight fit, but does work. Should accept up to a 20mm strap as long as it isn't unusually thick. I used a small flathead screwdriver to feed mine through, about 3/4 of a cm at
Source
Thingiverse
Comments
0

Comments

No comments yet – be the first!
All Thingiverse Models More by FlatHat

Add to Collection