Thingiverse
Charging Cable Holder
by cman342
0
Downloads
0
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/atsay7YYqoA
There is one thing you should do after printing. That thing is to glue or tape a Quarter on the bottom of the holder, this will make it heavier so it stays on the desk, table, counter, ect. Also, apply a substance on the bottom to give it more control and not slide around.
There is one thing you should do after printing. That thing is to glue or tape a Quarter on the bottom of the holder, this will make it heavier so it stays on the desk, table, counter, ect. Also, apply a substance on the bottom to give it more control and not slide around.
Sign in to leave a comment
Sign in