Thingiverse
SCX10 - Work stand
by whisslaren
413
Downloads
243
Likes
5
Makes
This is a work/display stand for Axial SCX10.
When assembled, the stand will clip on to the underside of the C-rails with magnets which means the stand will still be attached when the model is lifted, but is still easy to remove from the model.
The stand consists of two different parts and two of each are required to build it.
Needed to complete is 8 pieces of M3x20 screws and 4 pieces of 5mm diameter neodymium disc magnets.
The stand is designed to accept up to 10mm tall disc magnet
When assembled, the stand will clip on to the underside of the C-rails with magnets which means the stand will still be attached when the model is lifted, but is still easy to remove from the model.
The stand consists of two different parts and two of each are required to build it.
Needed to complete is 8 pieces of M3x20 screws and 4 pieces of 5mm diameter neodymium disc magnets.
The stand is designed to accept up to 10mm tall disc magnet
Sign in to leave a comment
Sign in