Thingiverse
TSX 220 and 250 Rear LED mount
by peeejayz
3
Downloads
2
Likes
1
Makes
Designed to fit an LED strip on the back of the TSX frames.
Print using supports - the middle is designed to slot onto the lower plate to stop this twisting.
The Nylon Spacer will fit directly inside of this mount.
Can be cut down if your LED strip is shorter.
Best printed at 2/3 shells and 20-30% infill.
Print using supports - the middle is designed to slot onto the lower plate to stop this twisting.
The Nylon Spacer will fit directly inside of this mount.
Can be cut down if your LED strip is shorter.
Best printed at 2/3 shells and 20-30% infill.
Sign in to leave a comment
Sign in