6 Pin MPX Plug (X3) Mount for 2020 or V-Slot Rail

This mount is designed for the 6 Pin MPX Plugs (see link below). They are a snug fit, but it wouldn't hurt to add drop of CA after they are set into position. These are being used for Hotend Wire Bundles and BLtouch/Proximity Sensor Wire Bundles. They could be using for any device you wish to easily unplug from the controller. Uses 2 each 4x10mm screws and 2 each 4mm drop-in T-nuts.

There is also a safety cap, in case you are not using all three connectors

Plug: http://www.banggood.com/6-