Thingiverse
Clip for LED Strip Aluminum U-Shape Channel (13mm wide)
by bratan
31
Downloads
7
Likes
0
Makes
I lost clips that came with my Aluminum Extrusion that holds LED strip, so I created my own. These will fit 13mm wide LED strip holder and will snap in place.
Included two versions one without hole (tested) and one with hole (untested). Unless you have very good 3D printer, rotate model 90 degrees on X: axes so it's standing up. This will help to eliminate bridges at the end of clip.
Print with ABS (in case LED fixture gets hot) and high fill, low layer height (0.2mm)
I couldn't print one wi
Included two versions one without hole (tested) and one with hole (untested). Unless you have very good 3D printer, rotate model 90 degrees on X: axes so it's standing up. This will help to eliminate bridges at the end of clip.
Print with ABS (in case LED fixture gets hot) and high fill, low layer height (0.2mm)
I couldn't print one wi
Sign in to leave a comment
Sign in