Thingiverse
Tablet into 3D Printer Control Center
by Lob0426
34
Downloads
32
Likes
1
Makes
1/19/16
10-3 mount adds more tilt to for a better view. Mount bevel 2 is 11mm shorter to better match the mount and bevel.
1/15/16
Mount Bevel 1 is attached to the Mount (10-2-mount) with 3M 20lb. tape. Hot glue is used at the top and bottom to make sure it will not peel loose over time. Mount Bevel attaches to the Tablet with 3M 20lb. double sided foam tape only. The Mount attaches to the printer side with 2 1" strips, 1 top 1 bottom across the mount. I used a cap head screw, washer and a
10-3 mount adds more tilt to for a better view. Mount bevel 2 is 11mm shorter to better match the mount and bevel.
1/15/16
Mount Bevel 1 is attached to the Mount (10-2-mount) with 3M 20lb. tape. Hot glue is used at the top and bottom to make sure it will not peel loose over time. Mount Bevel attaches to the Tablet with 3M 20lb. double sided foam tape only. The Mount attaches to the printer side with 2 1" strips, 1 top 1 bottom across the mount. I used a cap head screw, washer and a
Sign in to leave a comment
Sign in