Thingiverse
Stackable Icecube Tray
by MaximSachs
137
Downloads
113
Likes
0
Makes
A Stackable Icecube Tray.
After printing several, stack them on top of each other and start filling the first one. Once it is filled the fluid will automatically flow through the overflow drain and fill the next one. Make sure tho you rotate every next level by 90 or 180 degrees. Otherwise the drains will line up and the water will just drop down to the floor.
Printed using about 38m of PLA filament at 100% infill. I choose 100% to make it watertight.
Designed in Catia V5
After lett
After printing several, stack them on top of each other and start filling the first one. Once it is filled the fluid will automatically flow through the overflow drain and fill the next one. Make sure tho you rotate every next level by 90 or 180 degrees. Otherwise the drains will line up and the water will just drop down to the floor.
Printed using about 38m of PLA filament at 100% infill. I choose 100% to make it watertight.
Designed in Catia V5
After lett
Sign in to leave a comment
Sign in