Thingiverse
Dual fan cooling duct V5 for Flashforge Creator/Replicator dual
by ModelStation
236
Downloads
132
Likes
4
Makes
Note* I've uploaded a new version (v6) with ribs that prevent the bottom from distorting.
This is based upon my previous duct - which is based upon MasterFX's.
Changes are; a lager slot for more airflow, bottom more horizontal, and overall nicer look.
The screw holes are intentionally covered with a very thin layer. A screw should easily pierce through. You should only need two screws so I didn't see a need to leave the other holes open.
No supports required for printing.
This d
This is based upon my previous duct - which is based upon MasterFX's.
Changes are; a lager slot for more airflow, bottom more horizontal, and overall nicer look.
The screw holes are intentionally covered with a very thin layer. A screw should easily pierce through. You should only need two screws so I didn't see a need to leave the other holes open.
No supports required for printing.
This d
Sign in to leave a comment
Sign in