Thingiverse
Wind guide for HICTOP Desktop 3D Printer
by ACE1027
49
Downloads
37
Likes
0
Makes
UPDATE: Version 1.3
Honeycomb fan grill.
Printed at .125mm resolution (if you go any higher than this the honeycomb may not turn out so great.)
100% infill (just my own preference)
Printed with supports through CURA software.
Support Type: I printed this with Touching Build plate only setting. (Note: This is probably the most important setting for a fan guide designed like this. If you print this with supports everywhere, you will have difficulty fishing the supports from inside the enc
Honeycomb fan grill.
Printed at .125mm resolution (if you go any higher than this the honeycomb may not turn out so great.)
100% infill (just my own preference)
Printed with supports through CURA software.
Support Type: I printed this with Touching Build plate only setting. (Note: This is probably the most important setting for a fan guide designed like this. If you print this with supports everywhere, you will have difficulty fishing the supports from inside the enc
Sign in to leave a comment
Sign in