Thingiverse
Flash Forge Creator Pro - active cooling fan holder
by vindolin
25
Downloads
7
Likes
0
Makes
Snap on 40mm nozzle fan holder.
I'm using mostly the right extruder so that's what I build this for.
But there is also left version and a center one.
I'm not sure how good the center version works as the fan is blowing between the two nozzles.
It simply snaps into the two small holes on top of the extruder carriage.
Screw the 40mm 24v fan with two little 2.5mm screws to the holder and connect the fan cable to the unpopulated FET6 connector on the Mightyboard.
Especially PLA print q
I'm using mostly the right extruder so that's what I build this for.
But there is also left version and a center one.
I'm not sure how good the center version works as the fan is blowing between the two nozzles.
It simply snaps into the two small holes on top of the extruder carriage.
Screw the 40mm 24v fan with two little 2.5mm screws to the holder and connect the fan cable to the unpopulated FET6 connector on the Mightyboard.
Especially PLA print q
Sign in to leave a comment
Sign in