Wanhao Duplicator 4S Y-axis pillow blocks & supports

Both the front and rear y-axis shafts on my 4S were wobbling quite a bit after just 3 weeks of use. Wobble was ~2mm at the center of the shaft but it started affecting the print quality.

There are many pillow blocks here for Replicator clones, but none of them fit for 4S steel frame + it's not fun to drill that hard steel so I decided to try to utilize existing screw holes. These wont eliminate the wobble 100% (at least not for me as my shafts were already bent) but it will make it insignific