Thingiverse
Y Belt holder
by Monti00
0
Downloads
0
Likes
0
Makes
This thing was made with Tinkercad.
It is a GT2 belt holder to be attached to a support profile under the print bed. It has 2 holes of 6.5mm which need an M8 thread to be cut, so that you can use tightening screws.
Holds very firmly but might need a piece of filament to initially guide the belt through the openeings. Printed with 0.4mm nozzle in ABS
It is a GT2 belt holder to be attached to a support profile under the print bed. It has 2 holes of 6.5mm which need an M8 thread to be cut, so that you can use tightening screws.
Holds very firmly but might need a piece of filament to initially guide the belt through the openeings. Printed with 0.4mm nozzle in ABS
Sign in to leave a comment
Sign in