Fabrikator Closed Chamber upgrade

Aim was to upgrade fabrikator to a closed chamber, to have a constant t° for printing.
This is lessimportant for PLA, but is important for ABS, Polycabronate.
Also it has reduce the noice a lot.
It's still possible to access from the top easly
You need to drill your slef the holes, and trace it (easy)

What's needed:

Plexiglass 4mm:

Left part: 20 x 24 cm
Right Part: 20 x 24 cm (do not insert screw in top right, ot od not block stepper motor)
Top:
24.5 x 5 cm (Two times)
21 x 5 cm