Back
IKEA FLYGEL Lamp Support – 3D printable model from Thingiverse Thingiverse

IKEA FLYGEL Lamp Support

by pmm
3 Downloads
3 Likes
1 Makes
Download Model
The IKEA FLYGEL lamp is an inexpensive Halogen desk lamp. Unfortunately, the support struts are very weak. At best, the lamp would often slowly slip down; and if you put any side pressure on it, the supports would snap.

So, I measured and prepared this replacement. Remove the lamp arm by unscrewing the side bolts all the way on both sides. Use pliers or a dremel to remove the old struts; I used pliers and it was surprisingly easy to snap off the remaining undamaged strut. Then clean it up wi
Source
Thingiverse
Comments
0

Comments

No comments yet – be the first!
All Thingiverse Models More by pmm

Similar Models

6 Suggestions

Add to Collection