Thingiverse
New experimental Z-axis coupler
by devijvers
0
Downloads
4
Likes
0
Makes
Here is the STL file, I've unfortunately accidentally deleted the SCAD file, will have to start over again.
The bottom (lower) part is screwed on the threaded rod (open M8 nut inside, one M8 washer and one M8 nut below). The top (higher) part is screwed on the motor shaft with one M3 nut and one M3x10 screw.
Both parts are attached with 4 M3 nuts and 4 M3x10 screws.
With this design it should be possible to assemble/disassemble multiple times without damaging the printer parts. Warning:
The bottom (lower) part is screwed on the threaded rod (open M8 nut inside, one M8 washer and one M8 nut below). The top (higher) part is screwed on the motor shaft with one M3 nut and one M3x10 screw.
Both parts are attached with 4 M3 nuts and 4 M3x10 screws.
With this design it should be possible to assemble/disassemble multiple times without damaging the printer parts. Warning:
Sign in to leave a comment
Sign in