Thingiverse
OpenRC 4WD Truggy Chassis and Sides to fit smaller print beds
by KENisFIS
66
Downloads
28
Likes
0
Makes
UPDATES
2013/09/30
After printing out the rest of the parts, I discovered a small error in the design of the front plate. I have fixed and replaced the STL.
2013/08/22
My print bed is maxed out at 150mm x 150mm so I redesigned the large parts starting with the chassis plates.
The chassis is now in 3 parts that interlock together.
The side guards are in 2 pieces that slide together.
For extra support of all the pieces, I created a slot in the side guards for the chassis to fit i
2013/09/30
After printing out the rest of the parts, I discovered a small error in the design of the front plate. I have fixed and replaced the STL.
2013/08/22
My print bed is maxed out at 150mm x 150mm so I redesigned the large parts starting with the chassis plates.
The chassis is now in 3 parts that interlock together.
The side guards are in 2 pieces that slide together.
For extra support of all the pieces, I created a slot in the side guards for the chassis to fit i
Sign in to leave a comment
Sign in