MPCNC 3d printer bed plate holders

This is a set of holders for the MPCNC or any other type of stationary bed system for a 3d printer

There is a corner, side, and center piece to use as you see fit. I used #6x1/2" wood screws to attach the plates to the plywood. The center plate has an oversized hole so the screw will seat below the top surface,

Mine are printed in Ninjaflex so there is a little flex to make up for any warping of my plywood printer base. My printer has a 18"(450mm) x 24"(600mm) bed x 3/8"(16mm) aluminum