180* Filament Guide on a bearing.

I built this as a filament guide for my printer, i have my drybox on top of the enclosure and run my filament in the back wall, so i needed a nice 180* turnaround for the material, its intended to be mounted on 1/8" flatbar (i am using aluminum 3/4" x 1/8") with a single m3 (or similar) machine screw and nut, the bearing used is a standard skateboard bearing 8mm inside 22mm outside and 7mm wide. And i intend to glue the "cap" piece in place after inserting the bearing and roller piece, it will l