Thingiverse
MPCNC Z Axis Limit Switch Holder
by RxBConcept
167
Downloads
78
Likes
0
Makes
This is a simple Z axis limit switch holder for the MPCNC.
They are two variants, one for use with a reprap style limit switch board and one for use with a bare micro-switch.
In both case the micro-switch must have a straight lever and must be wired in a normally closed mode.
This means that if you're using the reprap style board, you must:
1. desolder the micro-switch
2. Add small wires to deport the micro-switch.
3. Solder the wires to the board, switching the NC and NO connections.
They are two variants, one for use with a reprap style limit switch board and one for use with a bare micro-switch.
In both case the micro-switch must have a straight lever and must be wired in a normally closed mode.
This means that if you're using the reprap style board, you must:
1. desolder the micro-switch
2. Add small wires to deport the micro-switch.
3. Solder the wires to the board, switching the NC and NO connections.
Sign in to leave a comment
Sign in