Thingiverse
Hesine-Omni-M505_Z-Axis_Endstop
by Lloyd_Hayes
5
Downloads
5
Likes
0
Makes
This is my new Z-Axis endstop for the Hesine M-505, or Omni M-505 printer. (Same printer) The original design was a pain to adjust. You had to get an allen wrench behind the threaded rod to adjust the original endstop.
I had these button endstops, so I designed this one which is easier to get at in order to adjust the Z-height. It's not perfect, but it is much better than the original design.
It requires:
A button endstop with a 12 mm barrel.
Two M3x16 screws with nuts.
No supports n
I had these button endstops, so I designed this one which is easier to get at in order to adjust the Z-height. It's not perfect, but it is much better than the original design.
It requires:
A button endstop with a 12 mm barrel.
Two M3x16 screws with nuts.
No supports n
Sign in to leave a comment
Sign in