Thingiverse
Headplay FPV battery case
by miharix
8
Downloads
4
Likes
0
Makes
Old battery of my Headplay FPV googles was bad.
I disordered the PCB and all smd components except the [10K voltage divider resistor](http://www.rcgroups.com/forums/showthread.php?t=1537992).
Then I flipped the black connector so I could connect it when the PCB was flat in the liberator.
Next the PCB was epoxy glued.
The battery is now [GENS ACE 4000MAH 7.4V 30C 2S1P HC 9](http://www.lipo.si/izdelek/G-30C40002S1PHC9/gens-ace-4000mah-74v-30c-2s1p-hc-9)
And the extended case is 3Dprinted.
I disordered the PCB and all smd components except the [10K voltage divider resistor](http://www.rcgroups.com/forums/showthread.php?t=1537992).
Then I flipped the black connector so I could connect it when the PCB was flat in the liberator.
Next the PCB was epoxy glued.
The battery is now [GENS ACE 4000MAH 7.4V 30C 2S1P HC 9](http://www.lipo.si/izdelek/G-30C40002S1PHC9/gens-ace-4000mah-74v-30c-2s1p-hc-9)
And the extended case is 3Dprinted.
Sign in to leave a comment
Sign in