Thingiverse
Drag Racing Christmas Tree
by ZAVALA
211
Downloads
193
Likes
0
Makes
3D Printed Drag Racing Christmas Tree i Designed in CAD.
The Pre-stage and Stage lights are Designed to hold 3mm led's.
The rest of the lower lights are all designed to take 5mm led's.
The bottom piece is designed to hold two AAA Batteries.
I used a Attiny84 to control the lights and i Programmed it with an Arduino Uno.
Six 3mm screws are needed to assemble the light to the bottom and the two bottom pieces together.
Below is a video of the assembled light.
https://www.youtube.com/wat
The Pre-stage and Stage lights are Designed to hold 3mm led's.
The rest of the lower lights are all designed to take 5mm led's.
The bottom piece is designed to hold two AAA Batteries.
I used a Attiny84 to control the lights and i Programmed it with an Arduino Uno.
Six 3mm screws are needed to assemble the light to the bottom and the two bottom pieces together.
Below is a video of the assembled light.
https://www.youtube.com/wat
Sign in to leave a comment
Sign in