eMAKER Huxley Remixed Bowden Extruder for use with E3D V6

Comments
-----------------------------
This extruder part was remixed in order to support the official E3D V6 Lite Bowden extruder 1.75 fitting. This part was required because the original eMAKER Huxley only permitted a 2.2mm PTFE tube. E3D ships with a 4.2mm tube.

We purchased the hardware from Home Depot in the Pipe fitting section. The Part number was LFA-708. It was a 1/8FIP brass Cap. We drilled out the center to push the PTFE tube all the way to the hobbled bolt for better align