V6 hot end c clamp mod to hold 12mm proxy sensor

As i bought a full steel X carriage the china type.
it has multi ways to setup your extruder.
what i did was go bowden style with a Mk8 cheap extruder kit ( the yellow one)
bought a cheap vulcano ( also china knock off )
and a long heat break 1.75.
I then screwed the heatbreak in the tapped 6mm hole leaving the hotend hole open.
put a lock on under neath and a hot end body on the top to secure it even futer.
this also allowed me to get the bowden tube in place
Gaining about 1 inch in Z t