Thingiverse
Toe Spike
by shaetano
204
Downloads
140
Likes
2
Makes
Mandalorian Toe Spikes similar to Boba Fett's ones worn in Empire Strikes Back.
I initially printed this at a 45 degree angle as printing with support is a must; but I wanted to keep the tip holes free from support material. In hindsight i suspect printing it at 90 degrees would be better as all the marks left from supports would be on the inside - boot side and not be visible out.
I initially printed this at a 45 degree angle as printing with support is a must; but I wanted to keep the tip holes free from support material. In hindsight i suspect printing it at 90 degrees would be better as all the marks left from supports would be on the inside - boot side and not be visible out.
Sign in to leave a comment
Sign in