Thingiverse
Diatone ET 160 cable & antenna holder
by patrikstrid
49
Downloads
33
Likes
0
Makes
I needed something to hold the battery wires out of the way from the props, and a holder for the antenna wires. So designed this.
It is designed to go on the top plate, using the 2 original back screws to hold it in place. I have made it so you can run the xt60 connector through it. I also drilled out the back hole in my top plate to take an antenna sma connector.
The antenna holder is designed for 3.2mm antenna tubes, and i also made a channel from the underside to the antenna tubes which wil
It is designed to go on the top plate, using the 2 original back screws to hold it in place. I have made it so you can run the xt60 connector through it. I also drilled out the back hole in my top plate to take an antenna sma connector.
The antenna holder is designed for 3.2mm antenna tubes, and i also made a channel from the underside to the antenna tubes which wil
Sign in to leave a comment
Sign in