Thingiverse
"1405 Simple X ends" Bed Spacers
door teknogeek1300
15
Downloads
16
Likes
0
Makes
Addon to this thing:
http://www.thingiverse.com/thing:377357
The issue I had was that the bed sat too low after upgrading to the simple X ends, making my Z coupler collide with my Y motor, this brings the bed up to an acceptable height(close to factory height) elimination banding issues with having the lower the Z coupler too far.
http://www.thingiverse.com/thing:377357
The issue I had was that the bed sat too low after upgrading to the simple X ends, making my Z coupler collide with my Y motor, this brings the bed up to an acceptable height(close to factory height) elimination banding issues with having the lower the Z coupler too far.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
