Thingiverse
Simple box for Raspberry Pi 2B and 3B
by BrunoBellamy
22
Downloads
17
Likes
1
Makes
Yet another case for your Raspberry Pi (compatible with models 2B and 3B). :)
I know, there are already a lot of them, but I wanted to make one by myself, to welcome my brand new 3B model… ;)
Warning : this box is fit for traditionnal computer use and media center. There are no holes for PiCam connector and GPIO connectors.
You'll need 4 M3x16 screws and nuts to close it. Be careful not to tighten the screws too much, or you might break the printed parts (always be gentle when tightening
I know, there are already a lot of them, but I wanted to make one by myself, to welcome my brand new 3B model… ;)
Warning : this box is fit for traditionnal computer use and media center. There are no holes for PiCam connector and GPIO connectors.
You'll need 4 M3x16 screws and nuts to close it. Be careful not to tighten the screws too much, or you might break the printed parts (always be gentle when tightening
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in