Thingiverse
QAV-R motor Shield
by meoster
71
Downloads
45
Likes
0
Makes
QAV-R motor shield. Would likely need to replace screws to M3x8 for these.
Tested on ABS. Will try flex later.
Sorry, made the bottom 3mm and realised the screws won't have enough thread on the motors.. Will upload v2 shortly with 2mm base.
V3 forgot to extend the base....
Note don't use flex material on this design. Screw on the flex material won't tighten up.
Tested on ABS. Will try flex later.
Sorry, made the bottom 3mm and realised the screws won't have enough thread on the motors.. Will upload v2 shortly with 2mm base.
V3 forgot to extend the base....
Note don't use flex material on this design. Screw on the flex material won't tighten up.
Sign in to leave a comment
Sign in