Thingiverse
Sony Xperia M4 holder
by MrCrankyface
10
Downloads
17
Likes
1
Makes
Just a very basic holder for Sony Xperia M4.
Ment to be printed in PLA and Ninjaflex or similar soft plastic.
The idea is to make the holder out of PLA and then print the 'sleeves' which will hold the phone with ninjaflex, to reduce vibrations and provide less harsh of a grip.
The bracket is ment for a 1" / 25.5mm bar, commonly found on motorcycles.
You can print thicker sleeves to adjust for smaller bars though.
Hardware needed:
1x m4x30
3x m4x20
2x m4 nuts
Check me out at:
Yo
Ment to be printed in PLA and Ninjaflex or similar soft plastic.
The idea is to make the holder out of PLA and then print the 'sleeves' which will hold the phone with ninjaflex, to reduce vibrations and provide less harsh of a grip.
The bracket is ment for a 1" / 25.5mm bar, commonly found on motorcycles.
You can print thicker sleeves to adjust for smaller bars though.
Hardware needed:
1x m4x30
3x m4x20
2x m4 nuts
Check me out at:
Yo
Sign in to leave a comment
Sign in