Thingiverse
Hesine Prusa i3 Adjustable Z Axis Endstop
by Kureigu
96
Downloads
82
Likes
3
Makes
After getting frustrated with the "hit and hope" method of adjustment for the factory supplied endstop, I set about designing a more precise and (almost) drop in replacement adjuster. After getting the basic design finished, a couple test prints done and with a few minor dimensional changes here are the results. (Photo shows pre-final design.)
You will need 1 M3 nut and 3 extra M3 screws to use this design. 2* M3x25mm and one fairly long screw of a length of your choice, I arbitrarily picked
You will need 1 M3 nut and 3 extra M3 screws to use this design. 2* M3x25mm and one fairly long screw of a length of your choice, I arbitrarily picked
Sign in to leave a comment
Sign in