Thingiverse
Raspberry Pi 2 Simple Enclosure
by noen
22
Downloads
10
Likes
0
Makes
A very simple Raspberry Pi 2 / 3 Enclosure. It uses 4 screws with countersinks in the bottom plate. This is about as simple as you can get for a full Pi enclosure.
Screws should be M2.5 to match the mounting holes for the board, or #2's should work as well.
Parts have been printed and test fitted against multiple Pi2 boards. Recommended print settings with PLA: .2mm height, 100% infill, no raft, no supports. If your printer is pretty well dialed in, you shouldn't need supports for
Screws should be M2.5 to match the mounting holes for the board, or #2's should work as well.
Parts have been printed and test fitted against multiple Pi2 boards. Recommended print settings with PLA: .2mm height, 100% infill, no raft, no supports. If your printer is pretty well dialed in, you shouldn't need supports for
Sign in to leave a comment
Sign in