Snap fit 9 Pin VGA / Serial / D-Sub type connector housing

I needed a 9 pin VGA / D-sub type connector for a printer wiring loom i'm working on.
I saw Gary Hodgsons http://www.thingiverse.com/thing:10456 which was nice - but too fragile and a bit clunky (because it needs vitamins.)
This is a ground-up remodel inspired by that, but utilising http://www.thingiverse.com/thing:33790 so that it'll snap-fit together.
this should be a lot stronger than thing:10456 with the added advantage that it should print lovely in PLA!
This should also scale in th