Thingiverse
DaVinci Filament Spool Holder
by ne14pez
127
Downloads
86
Likes
2
Makes
Spool mounts on the rear of the printer. There are other similar designs to this one, but I wanted one that incorporates a filament guide into the same piece. I found that the other filament guides would come loose if not attached really well.
Fits standard 2" diameter spools. The width is just right to fit between the fins on the inside of the back panel so make sure to line that up.
Video here: https://youtu.be/zRUPfSDkC-M
Edit 9-11-16: I added a new piece just for a filament guide
Fits standard 2" diameter spools. The width is just right to fit between the fins on the inside of the back panel so make sure to line that up.
Video here: https://youtu.be/zRUPfSDkC-M
Edit 9-11-16: I added a new piece just for a filament guide
Sign in to leave a comment
Sign in