MKS Gen 1.1 Box for Sunhokey Prusa i3

The Sunhokey Printer has it's MKS Gen 1.1 controller board just hanging on the wall. So I made a case for it in FreeCAD.

You need:
- The Original M3 screws and nuts
- Print both parts :)
- 4 M3 5mm screws with nuts

I printed mine without support. To secure the nuts I used some hotglue. I misplaced the one lid-connector a bit. I needed to rasp a bit of material so the MKS could slide in. (Shown on the last picture.)