Tricopter Case

A case that I made for my Y6 hexacopter to protect the flight control board from the elements (mostly). It is composed of 3 pieces: The top (TricopterCaseTop.stl), which requires a 4x8cm piece of polycarbonate/acrylic to fit in the hole (so you can see in), the middle (TricopterCaseBottomOnly.stl) and the bottom, which goes below the main frame, and is very specific for my build (CaseSub.stl). This goes over the Tricopter V3 Frame from RCExplorer.se. The landing gear is meant for 10mm square tub