Wanhao Duplicator i3 LED mount

Thought this would be a good test thing to make and publish. Its a discrete and simple LED mount. It uses standard thru hole LED's in series, and attaches to the front of the printer where the stock cooler goes. It is wired in parallel with the extruder cooling fan.

* 2- #6 1/2" Machine Screws.
* 4- 5mm Clear or difused white LED
* 33 ohm resistor
* Any translucent film to go behind the rhino. (I used 3m tape which was perfect)
* HOT GLUE

The wider the angle the better for the LED's