PCB cutting test for iModela

This is PCB cutting test for iModela.
This is the pattern for the 32pin IC(e.g. ATmega328) to convert from 0.8mm to 25.4mm pitch.
(However, this is not practical.)

The width of the pattern (on the data) is min 0.3mm.
Between the pattern and the pattern is min 0.5mm.
I used a PCB milling software "WINSTER PCB for iModela"
http://www.a-t.co.jp/winstarpcb_imode.html

Gerver data were created using PCBE.
http://www.vector.co.jp/soft/winnt/business/se056371.html



"iModela" is the 3D