Thingiverse
3D Printing Plaque for Singapore Science Centre
2
Downloads
5
Likes
0
Makes
This was a special plaque we created to be installed at the Singapore Science Centre's new Tinkering Studios!
The words are on 4 "plates" sized to fit a Replicator 2 3d printer. Blank plates are there to extend the sign as tall or short as you place (6 plates tall make it a square). And a Corner Plate just has screw holes which are set 2cm from the edges. You may need to flip/mirror/rotate after print to get them the right direction.
Have fun and proudly showcase this! =)
The words are on 4 "plates" sized to fit a Replicator 2 3d printer. Blank plates are there to extend the sign as tall or short as you place (6 plates tall make it a square). And a Corner Plate just has screw holes which are set 2cm from the edges. You may need to flip/mirror/rotate after print to get them the right direction.
Have fun and proudly showcase this! =)
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in