Boroscope camera mount for SeeMeCNC Orion / Rostock

I was having a hard time getting a good angle from my webcam for monitoring prints, so I bought a cheap boro/endoscope from Amazon. I built it to attach to my E3D extruder mount, so your results may vary. The camera mount will not work on the factory aluminum hot end mount

Rev 1 a: added a cut out for a zip tie to hold the camera instead of a rubber band.
Rev 1 b : added a locating notch to the washer and the mount to reduce the amount of spinning the mount does.

Rev 2: added a seco