Thingiverse
mh-Filament Guide
by mh8
0
Downloads
0
Likes
0
Makes
This part sits on 2 LM8UU bearings that can slide along an axis aligned on the X axis.
It's designed for 3mm filament and has a notch to hold any filament guide tube with outer diameter inferior to 7mm. Drilling is possible to make that a little larger.
There are holes ready for zip-ties to hold the piece on the LM8UU bearings
Use double-sided clamps to create an elevated X-rail above the top of the printer.
This part was designed for Prusa Mendel i2. 3mm filament sometimes snaps wh
It's designed for 3mm filament and has a notch to hold any filament guide tube with outer diameter inferior to 7mm. Drilling is possible to make that a little larger.
There are holes ready for zip-ties to hold the piece on the LM8UU bearings
Use double-sided clamps to create an elevated X-rail above the top of the printer.
This part was designed for Prusa Mendel i2. 3mm filament sometimes snaps wh
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in