Thingiverse
Extruder Merger
by mokash770
458
Downloads
277
Likes
2
Makes
New version at https://www.thingiverse.com/thing:2808135
This part enables you to use 2 extruders with one hot end.
(1.75mm)
Iv'e tested it with a light6 and so far the concept works well, I just need to tweak the g_code a bit to deal with the excess material that hangs around after the purge of switching extruders.
You will need three 1/8 push fittings to connect this, the brass ones thread better for some reason but will need to be drilled to allow the bowden tube to pass through.
This part enables you to use 2 extruders with one hot end.
(1.75mm)
Iv'e tested it with a light6 and so far the concept works well, I just need to tweak the g_code a bit to deal with the excess material that hangs around after the purge of switching extruders.
You will need three 1/8 push fittings to connect this, the brass ones thread better for some reason but will need to be drilled to allow the bowden tube to pass through.
Sign in to leave a comment
Sign in