rostock carriage lm8uu clamp gt2 tensioner

Carriage remixed from OxPIT`s Rostock Carriage with LM8UU Screw Clamps and GT2 Belt Ziptie Tensioner / Coupler by DanMoto. To use belt clip feed belt through centre hole. Turn the belt on itself so teeth mesh. Put block through loop that is formed. Feed doubled belt back through centre hole. Use two hex headed m3 bolts and nuts for tensioning. A tiny bit of build height is lost and a longer end stop screw is needed.
Cut the small supports out of the belt clamp on the carriage so belt can exit t