Thingiverse
Printrbot PLUS V2 Top Stiffener Bracket for M8 hardware
7
Downloads
4
Likes
0
Makes
This dead simple and nifty bracket slips on (very firmly, may need some fettling) the top of the 2 x 12mm smooth rods on the Printrbot PLUS V2.
It's designned to take a length of M8 threaded rod and M8 nylock nuts in the recesses. You then want to use a plain or nylock nut on the other side so you can adjust the amount of "push" the brackets give on the smooth rods.
The additional hole up the top you can drill out and use as a filament guide or bolt something else into it.
I found the d
It's designned to take a length of M8 threaded rod and M8 nylock nuts in the recesses. You then want to use a plain or nylock nut on the other side so you can adjust the amount of "push" the brackets give on the smooth rods.
The additional hole up the top you can drill out and use as a filament guide or bolt something else into it.
I found the d
Sign in to leave a comment
Sign in