Yoshi Trophy with custom supports

It took a couple tries to get the angled foot to print properly.

The supported Yoshi is about 90mm tall.

I printed it at 0.2Layers, 10% infill, and a 4 wall thickness .

I will probably bump the infill a bit on the next print.

This model was converted from here: http://www.models-resource.com/gamecube/ssbm/model/5337/

EDIT: 08/15/19 - Ran both files through Meshlab and Netfabb Basic. There was four small holes, but nothing breaking it up into multiple parts.